HB Industries CZ Bren 2 Extended Charging Handle
Description
Our Drop in Charging Handle for the CZ Bren 2 is extended in length by 3.5mm, and the height/width is increased 2.1mm. More importantly than the dimensional changes is HOW the geometry was changed. The factory charging handle assembly on the Bren is dynamic in that is engages several other components in the upper receiver. You might have noticed that the factory finger catch rotates such that when pulled to the rear the rake of the finger catch goes to “zero” or even negative. Our charging handle is designed with a more positive rake while in battery, and when operated, our finger catch never pulls into a negative rake. In addition to this we have also added an aggressive hook to tip of the finger catch that captures the operators finger.
Our Bren2 extended charging handle is machines from 6061T6 aluminum then hard coat anodized to MIL-A-8625. Each charging handle is supplied with replacement roll pins and a taper dowel pin to aid in installation.
3.5mm Extended Charging Handle For Bren 2
Drop In Replacement, Ambidextrous
Continuous Positive Rake
Increased Clearance to Optics
Drop In Replacement
Machined Aluminum 6061-T6
Anodized MIL-A-8625 Type 3 Hard Coat
Designed and Manufactured completely in USA.
Gunsmith Installation Recommended for All Parts.